Vista Ademco -10SE Anleitung zur Fehlerbehebung PDF herunterladen (Seite 13)

100

–13–

b. Wire the other three terminals (Sync, Data, Com) on the 4300 transformer.

Wires from these terminals must be connected to a 9-pin connector on the

control board (using a 4142TR cable supplied with the 4300 transformer),

as shown in Figure 5. These particular wires can be 24 gauge or larger,

and can be run along with the AC and ground wires to the control panel.

123456789

9-PIN CONNECTOR

ON CONTROL BOARD

BLACK

BLUE

BROWN

GREEN

RED

WHITE

YELLOW

GRAY

VIOLET

4142TR CABLE

125 2

Earth

Ground

Sync

Data

Com

4300 TRANSFORMER/INTERFACE

TERMINALS

ON CONTROL

BOARD

THESE WIRES (7, 8, 9) NOT USED,

UNLESS 4146 KEYSWITCH

IS ALSO USED

Figure 5. Connections of 4300 Transformer To The Control Board

Installing The Back-Up Battery

If necessary, refer to

FINAL POWER UP

section for information regarding battery

size to use, etc.

Do not attach the connector cable to the battery terminals until you are

instructed to do so later in the manual.

1. Place the 12-volt back-up battery in the control cabinet.

2. Attach Red and Black wires on the battery connector cable as follows:

a. Red to the positive (+) battery terminal on the control board (see

Summary of Connections Diagram for location, if necessary).

b. Black to the negative (–) battery terminal on the control board.

Use a 4AH battery or larger for UL installations.

Earth Ground Connections

The designated earth ground terminal (25), must be terminated in a good earth

ground for the lightning transient protective devices in this product to be effective.

The following are examples of good earth grounds available at most installations:

Metal Cold Water Pipe: Use a non-corrosive metal strap (copper is

recommended) firmly secured to the pipe to which the ground lead is electrically

connected and secured.

AC Power Outlet Ground: Available from 3-prong, 120VAC, power outlets only.

To test the integrity of the ground terminal, use a three-wire circuit tester with

neon lamp indicators, such as the UL-Listed Ideal Model 61–035, or equivalent,

available at most electrical supply stores.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

Vista Ademco -10SE Anleitung zur Fehlerbehebung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Vista Ademco -10SE