Vista Ademco -10SE Anleitung zur Fehlerbehebung PDF herunterladen (Seite 60)

–60–

ZN ZT P RC IN: L

10 03 1 00 RF: 1 s

The summary screen for the zone will appear. Note that an "s" indicates

that a serial number has, in fact, been enrolled. The cursor will be

flashing above the loop number. Press [

] to accept the zone information.

NOTE: If you entered “0” in the "LEARN S/N?" prompt previously, you

will not get an indication that the serial number has been enrolled.

If you want to delete the serial number, enter "0" and press [

]. The

system will then prompt, "DELETE S/N?" Press the "1" (YES) key to

complete the delete sequence. This process deletes the serial number

only,

not

the loop number. The assumption is that the proper loop

number was programmed, but the wrong serial or loop number was

enrolled. To change the loop number, you must go back through zone

programming for that zone and manually enter the loop number over the

existing one.

PROGRAM ALPHA?

0 = NO 1 = YES 0

ENTER ZN NUM.

(00 = QUIT) 11

If you want to program alpha descriptors now, enter "1" (YES). See the

ALPHA DESCRIPTOR PROGRAMMING

section for more information.

If not, enter "0" (NO).

This will return you to the ENTER ZN NUM. prompt for the next zone.

When all zones have been programmed, enter “00” to quit.

If you plan to enroll serial numbers in the sequential mode, enter “00” to

quit, then go to the

SEQUENTIAL MODE

section later in this manual to

enroll the serial numbers.

When you have finished programming all zones (including all serial

numbers), test each zone using the system's TEST mode. Do not use the

Transmitter ID Sniffer mode for this, as it will only check for transmission of

one zone on a particular transmitter, and NOT the zones assigned to each

additional loop.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 99 100

Keine Kommentare

Vista Ademco -10SE Anleitung zur Fehlerbehebung Seite 60