Vista Ademco -10SE Anleitung zur Fehlerbehebung PDF herunterladen (Seite 80)

100

–80–

Keypad Functions

General Information Note that if you enabled QUICK ARM for the partition (field

21), the [#] key can

be pressed instead of entering the partition's security code, for any of the arming

procedures (Away, Stay, Instant, Maximum, etc.). The security code is alway

required, however, when disarming the system.

The keypad allows the user to arm and disarm the system, and perform other

system functions, such as bypassing zones, and display zone descriptors. Zone

and system conditions (alarm, trouble, bypass) are displayed in the Display

Window.

When an alarm occurs, keypad sounding and external sounding will occur, and

the zone(s) in alarm will be displayed on the keypad. Pressing any key will

silence the keypad sounder for 10 seconds. Disarming the system will silence

both keypad and external sounders. When the system is disarmed, any zones

that were in an alarm condition during the armed period will be displayed

(memory of alarm). To clear this display, simply repeat the disarm sequence

(enter the security code and press the OFF key) again.

The keypads also feature chime annunciation, and 3 panic key pairs, or individual

panic keys (depending on keypad type – see

Panic Keys

below), for silent,

audible, fire or personal emergency alarms. These keys can notify the central

station of an alarm condition, if that service is connected.

Arming Functions The following is a brief list of system commands. For detailed information

concerning system functions, refer to the User's Manual.

Disarmed, Not Ready ........... Before arming, the system must be in the READY

condition (all zones must be intact). If the "NOT

READY" message appears, press the READY [

]

key to display faulted zones.

Arming Away ........................ Enter code + AWAY [2].

Arming Stay .......................... Enter code + STAY [3].

Arming Instant ...................... Enter code + INSTANT [7].

Arming Maximum ................. Enter code + MAXIMUM [4].

Disarming .............................. Enter code + OFF [1].

Bypassing Zones ................. Enter code + BYPASS [6] + zone number(s).

Forced (Quick) Bypass........ (If enabled) To automatically bypass all faulted

zones, use the "Quick Bypass" method:

Enter code + BYPASS, then wait for all open

zones to be displayed. Arm when display

indicates “bypass” and “ready to arm”.

Chime Mode .......................... Enter code + CHIME [9].

To turn chime off, enter code + CHIME again.

SUMMARY OF ARMING MODES

Features for Each Arming Mode

Arming

Mode

Exit

Delay

Entry

Delay

Perimeter

Armed

Interior

Armed

AWAY Yes Yes Yes Yes

STAY Yes Yes Yes No

INSTANT Yes No Yes No

MAXIMUM Yes No Yes Yes

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

Vista Ademco -10SE Anleitung zur Fehlerbehebung Seite 80

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Vista Ademco -10SE