Vista Ademco -10SE Anleitung zur Fehlerbehebung PDF herunterladen (Seite 72)

100

–72–

10 INPUT S/N: L

Axxx xxxx

5. This prompt is displayed when the system has found the next zone which

needs to be enrolled. The system will respond to the first serial number

transmitted after the [

] key on the keypad is pressed. A serial number

may be enrolled by one of two methods:

a) Enter the 7 digit serial number printed on the transmitter

b) Activate the transmitter by faulting or restoring the input you wish to

use for that zone (e.g., press a button, open or close a door, etc.).

If you do

not

wish to enroll the zone displayed, press the [#] key on the

keypad or the upper right-hand button on the program tool (a long beep will

be heard to verify). The following prompt will appear:

10 LEARN S/N?

0 = NO, 1 = YES 0

To enroll now, enter "1" (YES). If "0" (NO) is entered, the following prompt

will appear if a program tool has already been programmed:

ENTER ZN NUM.

(00 = QUIT) 12

Zone Number Entered ↑

Enter the next zone number to be enrolled (e.g., zone 12). The system will

search for that zone and will display the prompt shown in the beginning of

step 5. If you wish to exit the enroll mode completely, enter 00 and press

[

10 INPUT S/N:L

A 022-4064 3

↑ ↑

Serial # Loop #

The system will enroll the serial number of the first transmitter heard, add

the loop number entered to this serial number, display the serial and loop

numbers, and cause the keypad to beep twice.

If the serial and loop number combination is already present in the system, a

single long beep will be heard from the keypad. If this happens, the system

will not display the serial number, but will wait for a transmission from another

transmitter or transmitter loop input.

6. The system will then enter an optional confirmation mode so that the

operation of the actual programmed input can be confirmed. Activate the

loop input or button that corresponds to this zone. We recommend that

you confirm the programming of every transmitter before

proceeding to the next zone.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

Vista Ademco -10SE Anleitung zur Fehlerbehebung Seite 72

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Vista Ademco -10SE