Vista Ademco -10SE Anleitung zur Fehlerbehebung PDF herunterladen (Seite 101)

Keypad Functions

General Infomlation

Note that if you enabledQUICK ARM for the partition (field *21), the [#l key

canbe pressedinsteadof entering the partition’s security code,for any of the

arming procedures(Away, Stay, Instant, Maximum, etc.).The securitycodeis

alwaysrequired, however,when disarmin

g the system.

The keypad allowsthe user to arm and disarm the system,and perform other

systemfimctions,suchas bypassingzones,and display zone descriptors.Zone

and system conditions(alarm, trouble, bypass) are displayed in the Display

Window.

When an alarm occurs,keypad sounding and external sounding will occur,

and the zone(s) in alarm will be displayed on the keypad. Pressing any key

vdl silence the keypad sounder for 10 seconds.Disarming the system will

silenceboth keypad and external sounders. When the system is disarmed,

any zones that were in an alarm condition during the armed period will be

displayed(memory of alarm). To clearthis display, simply repeatthe disarm

sequence(enter the securitycodeand pressthe OFF key)

again.

The keypads also feature chime annunciation, and 3 panic key pairs, or

individual panic keys (dependingon keypad type - see

Panic Keys below),for

silent, audible, fire or personalemergencyalsrms. These keys can noti@ the

centralstation of an alarm condition,if that serviceis connected.

Arming Functions

The

following is a brief list of system commands. For detailed information

concerningsystemfanctions,refer to the User’s Manual.

Disarme~ Not Ready ....Before arming, the system must be in the

READY condition(all zones must be intact).If

the “NOT READY’ message appears,pressthe

READY [*] keyto displayfaultedzones.

Arming Away ......................

Enter code+ AWAY [2].

~ S~Y

. ....................... Enter code+ $TAY [31.

~ ~t

.................. Enter code+ INSTANT [7].

~~-

.............Enter code+ MAXtMUM [4].

Disarming

...........................

Enter code+ OFF [1].

Bypassing Zones ................

Enter code+ BYPASS [6]+ zonenumber(s).

Forced (Quick) Bypass .....

(lf enabled) To automatically bypassall faulted

zones, use the “Quick Bypass” method:

Enter code+ BYPASS, then wait for all open

zones to be displayed. Arm when display

idiCateS %Y’PSSS”and %eady to arm”.

Chime Mode ........................ Enter code+ CHIME [9].

To turn chimeoff, enter code+ CHIME again.

SUMMARY OF ARMING MODES

I Features for E~h i%znimz Mode I

Arming

Exit

Entry

Perimeter Kterior

Mode

Delay

ihmed

Ammed

AWAY

Yes Yes Yes

Yes

STAY

Yes

INSTANT

Yes No

Yes

Yes No Yes

Yes

-101-

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Vista Ademco -10SE Anleitung zur Fehlerbehebung Seite 101

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Vista Ademco -10SE