Vista Ademco -10SE Anleitung zur Fehlerbehebung PDF herunterladen (Seite 33)

Installing the 5SS1/58?32 Receiver

RF System InstaUationAdvisories

Disregard the following advisories if the receiver is mounted in the control

cabinet as described in Section 2.

Placethe RF Receiverin a high, centrallylocatedareafor bestreception.

Do not locate the receiver or transmitters on or near metal objects.This

will decreaserange and/or blocktransmissions.

Do not locatethe receiverin an area of high RF interference(revealed by

frequent or prolonged lighting of the LED in the receiver. . random

flickeris OK).

The RF receiver must be at least 10 feet from any remote keypads to

avoidinterferencefrom the microprocessorsin those-units.

InstaUation

and Setup of the 5S81/5882 Receiver

Set the receiver’s DIP switch for deviceaddress “O”,as described in its

instructions(all switchesto the right. . . “off”).

Mount the receiver.The RF receivercan detectsignalsfrom transmitters

within a nominal range of 200 feet. Take this into consideration when

determining mounting location.

Connectthe receiver’swire harness to the control’skeypad terminals (4,

5, 6, and 7). Plug the connectorat the other end of the harness into the

receiver.

Refer to the installation instructions provided with the receiver for

further installation proceduresregarding antenna mounting, etc.

NOTt2WHENCIRCUITBOARDISMOUNTEDIN

TOCONTROL’S

REMOTEKEYPAD

CONNECTION

POINTS.

13gure

12. 5S81/58S2 RF Receiver (cover removed)’

-33-

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 119 120

Keine Kommentare

Vista Ademco -10SE Anleitung zur Fehlerbehebung Seite 33