Vista Ademco -10SE Anleitung zur Fehlerbehebung PDF herunterladen (Seite 42)

Rek@Powerlime Carrier Device Basks

Relays and Powerline Carrier devices (ex. X-10 brand devices) are

programmable switchesthat canbe used to perform many difRerentfunctions.

They can be used to turn lights on and off, control sounders, or for status

indications. In this system,each devicemust be programmed as to how to

act (ACTION), when to activate (START), and when to deactivate (STOP).

Each of these is describedbelow,and in the progr

axnmingprocedure for *8O

and *81 interactivemodesthat me provided at the end of this section.

The control supports a total of 8 output devices in the following

con.@urations:

● One 4204 relay module (4 relays) and 4 PowerlineCarrier devices.

● One 4229 zonehelay module (2 relays) and 6 PowerlineCarrier devices.

c Up to 8 Powerline Carrier devices(8 minus the number of output relays

used).

The 4204 and 4229 modules provide Form C (normally open and normally

closed)contacts. Powerline Carrier devicesare controlled by signals sent

through the electrical wiring at the premises via a 4300 transformer.

Therefore, if using Powerline Carrier Devices, a 4300 transformer

must be

usedin placeof the regular systemtransformer.

In *8O and *81 interactive modes, a series of keypad prompts wdl request

entries for progr

amming of the Relay outputs and/or Powerline Carrier

devicesused in the system. Refer alsoto “OUTPUT RELAYS/POWERLINE

CARRIER DEVICES WORKSHEET FOR *8O AND *81 INTERACTIVE

MODES” in the blank programming

g form.

4204 and 4229 Reky Modules

4204/4229 -p

The 4204

or 4229 unitcan be mounted either remotelyor in the controlpanel.

The following stepsshouldbe taken to properly setup the 4204 or 4229:

1. Connect the 4204/4229 to the control’s Partition 1 remote keypad

terminals (4-7),

using the connectorsupplied with the 4204 and 4229.

Use standard 4conductor twistedcablefor long wiring runs.

2. Set the 4204/4229’s D~ switch for a device address of ‘l” (switch 2

“OFF” md switches3, 4, 5 “ON”). Switch 1 determines tie tit’s cover

tamper response(“ON

= disabled,“OFF”= enabled).

3. Connect the desired field wiring to the unit’s relay contactterminals.

Supervision

c 4204

and 4229 modules are supervised against removal. CHECK and

zone 09 will be displayed if a module is disconnectedfkom the control’s

txxminals

(4,5,6, & 7).

42-

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Vista Ademco -10SE Anleitung zur Fehlerbehebung Seite 42

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Vista Ademco -10SE