Vista Ademco -10SE Anleitung zur Fehlerbehebung PDF herunterladen (Seite 102)

Panic Keys

Rela#Powdine Carrier

(if used)

42S5 Voice

Module

(if

used)

Esit Error AlaraI

-b

(if programmed)

There are three panic key pairs or (on some keypads) lettered keys that, if

programmed, can be used to manually initiate alarms and send a report to

the central station.

Each can be individually programmedfor 24hour Silent,Audible, Personal or

Fire Emergency responses.The panic function is activatedwhen both keys of

the appropriate key pair are pressed at the same time, or the appropriate

lettered key is pressedfor at least 2 seconds.

The panic fimctions are identified by the systemas follows

Keys

Displayed as Zone

Notes:

[11& [*I, or [Al

Keys [A], [B], [C] are not on all

[*I & [#l, or OX

keypads.

● Key [D], if present, is not active

[31& [#l, or [Cl

here.

Zmportant: For the Silent Panic functions to be of practical value, the

systemmust be connectedto a centralstation. “

If relay outputs (via a 4204, or 4229), or Powerline Carrier devicesare used,

two keypad entries available to the user are included. They can manually

activateor deactivatethe device(s)for start@ or stoppingsomeaction,such

asturning lights on or off, etc.

Thesekeypad enties are:

Security Code + [#] + [71 + Device # activates(starts)that device.

Security Code + [#] + [8] + Device # de-activates(stops)that device.

Refer to the separate instructions supplied with the Voice Module for

information concerningits operating procedures.

Note: The Voice Module cannot be used to add user codesin this system.

User codesmust be added by usimza wired kevoad.

● A display of “CANCELED ALARM?’

or “CA” and a zone indication

will

appear if an exit or interior zone contained a fault during closing at

the time the ezit delay ended (e.g.,exit door left open),

but the system was

disarmed during the entry delay time. The alarm

sounder and keypad

sound continuously, but stop when the system is disarmed. No message

Willbetr ansmittedto the central station.

● A display of “EXIT

ALARM” or “EAt’ and a zone indication will

appear if an exit or interior zone contained a fault during closing at the

time the exit delay ended,

but the system was NOT disarmed during the

entry delay time. The alarm

sounder and keypad sound continuously until

the system is disarmed (or timeout occurs). An “exit alarm” messageis

sent to the central station.

“ The “EXIT ALAFtNF’ display, etc. will also result if an alarm from an

exit or interior zone occurs within two minutes after the end of an exit

delay.

In any of the abovecases,use a secondOFF sequence(codeplus OFF key) to

clearthe display.

-102-

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Vista Ademco -10SE Anleitung zur Fehlerbehebung Seite 102

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Vista Ademco -10SE