Vista Ademco -10SE Anleitung zur Fehlerbehebung PDF herunterladen (Seite 28)

This sectionprovides information regarding the use of expansion modules for expanding the

number of wired zones in the system, the modules that can be used and their wiring

connections,plus a procedurefor progr

amming the wired expansionzones.

Im@ling Zone Expansion

Units

You can add an additional 8 wired EOLR zones to the basiccontrol’s8 zones,

for a total of 16 wired zones,by using a No. 4219 Wired Expansion Unit, or

4229

Wired ExpansionLRelay Unit.

Location

●

Supervision

●

Zone Information “

You can mount an expansionunit within the control

cabinetif spacepermits. Otherwise, mount the unit

outsidethe cabinet.

Units are supervised against removal. Keypads will

display CHECK and zone 09 if a zone expander is

disconnected.

Units have tamper protection for security when

mounted outsideof the cabinet.

Assign zone numbers 10-17 for the eight wired

expansion loops (designated A to H). You can

program thesezonesindividually (in *56 interactive

mode) for Partition 1 or 2. See“Bog-ramming Wired

Expansion Zonesnlater in this section.

Connections

and Set-Up

OFF++ ON

-+2.

Connect the 4219 or 4229 module to the control’s keypad terminals (see

diagram below).

Set the 4219 or 4229’s DIP switch for device address “l” (switch 2

“OFF and

switches3,4, 5 “ON”). Switch 1 determinesexpansionzone As

response time (“ON’ = normal response, “OFF” = fast response). For

location of the DIP switch in the unit, see the diagram below (location of

DIP switchfor both units is in the samelocation).

For additional information, seeinstructions supplied with the 4219 and

4229.

RELAY

~ pFl

REyY = + Qlp~cH

4229

CONNECTOR.

FORS1311NGADORESS

ANDZONE‘A-RESPONSE

TERMINALSON

CONTROLPANEL

OL+ (TERM6)

D + (TERM4)

+ (7ERM5)

+ (TERM7)

l%gure 11. Wiring Connections,

4219 & 4229 (4229 shown)

-28-

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Vista Ademco -10SE Anleitung zur Fehlerbehebung Seite 28

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Vista Ademco -10SE